Support for SnapNrack Ultra Rail Comp Flashing with L Foot Bracket and 4″ Umbrella Lag Bolt
Installing the SnapNrack Comp Flashing with SnapNrack Ultra Rail L Foot involves several steps to ensure a secure and watertight connection between the roof and the solar panel mounting system. Here’s a step-by-step guide:
Gather Necessary Tools and Materials:
- SnapNrack Comp Flashing
- SnapNrack Ultra Rail L Foot
- Roof flashing sealant (compatible with your roofing material)
- Lag bolts or screws (appropriate size for your roof)
- Drill with appropriate bits
- Wrench or ratchet set
- Safety gear (gloves, goggles, etc.)
- Ladder or scaffolding (if necessary)
Prepare the Roof Surface:
- Ensure the roof surface is clean and free of debris.
- Identify the correct location for installing the Ultra Rail L Foot. It should be positioned to align with the rafters or structural supports beneath the roof.
Install the Comp Flashing:
- Place the SnapNrack Comp Flashing over the intended installation area on the roof.
- Use a pencil or marker to mark the locations of the mounting holes on the flashing.
- Drill pilot holes at the marked locations to prepare for the lag bolts or screws.
Apply Roof Flashing Sealant:
- Apply a generous amount of roof flashing sealant to the underside of the Comp Flashing.
- Ensure that the sealant covers the area around the mounting holes to create a watertight seal.
Attach the Comp Flashing to the Roof:
- Position the Comp Flashing over the pilot holes on the roof.
- Secure the Comp Flashing to the roof using lag bolts or screws. Be careful not to over-tighten, as this could damage the flashing or roof surface.
Install the Ultra Rail L Foot:
- Place the SnapNrack Ultra Rail L Foot over the mounted Comp Flashing.
- Align the holes in the L Foot with the pre-drilled holes in the Comp Flashing.
Secure the L Foot to the Comp Flashing:
- Insert lag bolts or screws through the holes in the Ultra Rail L Foot and into the pre-drilled holes in the Comp Flashing.
- Use a wrench or ratchet set to tighten the bolts securely.
Repeat as Necessary:
- Repeat the installation process for each mounting location along the roof, ensuring proper spacing between the Ultra Rail L Feet according to the specifications provided by SnapNrack.
Final Inspection:
- After completing the installation, inspect each mounting point to ensure the Comp Flashing and Ultra Rail L Feet are securely attached and properly sealed.
- Check for any signs of gaps or leaks around the flashing sealant.
Documentation:
- Keep detailed records of the installation, including the locations of the Comp Flashing and Ultra Rail L Feet, as well as any relevant information.
Always refer to the specific instructions provided by SnapNrack for detailed guidance on installing their products. If you encounter any difficulties or uncertainties during the installation process feel free to call and speak to one of our Hufft Solar professionals, or consult a qualified roofing or solar installation professional in your area for assistance.